SD card

SD card

Introduction and Setup of Raspberry Pi

Published in Anudeep Juluru, Shriram K. Vasudevan, T. S. Murugesh, fied!, 2023

Anudeep Juluru, Shriram K. Vasudevan, T. S. Murugesh

Initially, insert the micro SD card into your SD card reader and connect it to a PC for formatting it. Next, you need to download an OS and flash it to the formatted micro SD card. You can do all these steps using a single software, Raspberry Pi Imager developed by the Raspberry Pi organization. It can be downloaded from this link (https://www.raspberrypi.org/software/). Choose the appropriate software variant and click download. As we are using a PC with Windows OS, we’ll download Raspberry Pi Imager for Windows as shown in Figure 29.3.

Applications of IoT Lab Kit in Educational Sector

View Article

Journal Information

Published in IETE Journal of Education, 2019

N. M. Shweta, V. Tulasi Dwarakanath, K. Nanda, S. Saha, V. P. Singh, P. Hari Babu, B. S. Bindhumadhava, G. L. Ganga Prasad

Wingz also supports clock speed up to 1 GHz, 1 GB/2 GB DDR3 SDRAM, 4 GB/8 GB onboard eMMC(Embedded Multimedia card) flash memory, External Micro-SD card support (up to 32 GB), Onboard Gigabit Ethernet, USB 2.0 with OTG (On the go) Support, High quality Stereo audio codec with 3.5 mm audio port for Audio In/Out, High Range IEEE802.15.4 (ZigBee/6LoWPAN) Transceiver (up to 22 dBm Tx power),WLAN (IEEE802.11b/g/n), Dual mode Bluetooth (BLE), 3G, GPS. It also has on board Temperature and Relative Humidity Sensor, Digital Ambient Light Sensor and 3-Axis Digital Accelerometer. Figure 10 shows the pictorial view of WINGZ Multi-Protocol gateway. The display and console unit has 7 inch TFT (Thin Film Transistor) capacitive touch. The touch controller of the display works through I2C.

Explore chapters and articles related to this topic

Introduction and Setup of Raspberry Pi

Applications of IoT Lab Kit in Educational Sector